SIG Sauer 556 Arms Forum banner

SOLD Sig quad rail take off from 556 SBR Sig Covers

4550 Views 8 Replies 3 Participants Last post by  Basenji
This is a take off from my factory 556 SBR. Rifle has never been fired so these are like new. The covers have never been out of the plastic. $225 now$210plus shipping, descrete paypal OK +4%
Please email me
at [email protected]

I believe they will fit the p556, although the Samson site says something about with or without a flange. Don't know anything about the flange on a p556.

As you can see, below, the Troys and the Samsons are more expensive and the covers are additional.

Troy railed handguards for p556 $279
http://www.troyind.com/sig556.html


Samson railed handguardsl for p556 $309
http://www.samson-mfg.com/ar-15_html/product/STAR-SIG-556-S.html
1 - 9 of 9 Posts
The answer to the flange...

I went ot a gun show today and took a good look at a p556 with fishgills. They do not fit into the gas block like the regular handguards do and have a collar that holds them in place. The SWAT rails should work with the gas block when the collar is removed.
Reduced to $210 + shipping or best reasonable offer.
4
Now with pictures

I've been asked for pictures. Here they are:

How they fit with the gas block (while they were still on my SBR):


What they look like off the rifle:




What you get:
See less See more
how do I keep missing these???

second in line please! :?
Sent a PM to enigma, he was next in line. If you are there please reply. In any event, still avialable.
1 - 9 of 9 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top