Found Source for 552 Handguard Retainer | SIG Sauer 556 Forum

Found Source for 552 Handguard Retainer

Discussion in '556 Discussions' started by Accomplice, May 11, 2020.

  1. Accomplice

    Accomplice Active Member

    Messages:
    654
    Likes Received:
    27
    Trophy Points:
    28
  2. Accomplice

    Accomplice Active Member

    Messages:
    654
    Likes Received:
    27
    Trophy Points:
    28
  3. Accomplice

    Accomplice Active Member

    Messages:
    654
    Likes Received:
    27
    Trophy Points:
    28
    4AFDA8DB-A4CC-4017-B707-3AB0728DE663.jpeg I got the retainer from these guys today. Looks like a quality piece. The finish is glossy and appears to be pretty thick. When I drove out the pins, removed my gas block and got this bad boy on, it was just a hair big to fit back into the backside of the gas block. Needed a little encouragement from a wooden block to get in there.
     
    Mr.Maim and Tad_07 like this.
  4. Mr.Maim

    Mr.Maim New Member

    Messages:
    16
    Likes Received:
    5
    Trophy Points:
    3
    Awesome! Mine should be arriving in a couple days, just ordered last night and had a tracking number an hour later!

    I was unsure whether they were coated/painted/cerakoated and was starting to look for someone that could either parkerize or cerakote them. Glad they're finished.


    Waiting for pics with your modded handguards installed... soon? :)
     
    Accomplice likes this.
  5. Accomplice

    Accomplice Active Member

    Messages:
    654
    Likes Received:
    27
    Trophy Points:
    28
    Nice. I just requested a tracking number from gun factory. It was ordered a couple days ago so hopefully it’s already on its way but I never got a tracking number. Anybody know how quickly they get orders out? It looks like an old thread showed 17 days from order to delivery stateside.
     
    Last edited: May 13, 2020
  6. brent1089

    brent1089 New Member

    Messages:
    1
    Likes Received:
    0
    Trophy Points:
    1
    Slightly on topic: I was just about to order one of the JMAC retainer rings but I already have an MFI ring and handguard set. Would anyone know if the MFI retainer cap works with cutdown 550 handguards? I'm thinking of doing a cutdown project (the MFI handguards don't seem very stable) .
     

Share This Page